Build quality feels nice and sturdy. There is two notch openings in the bottom for you to run your power cord out. It also comes with a wall plate for duplex-styled outlets if you have those instead of the decora-styled ones. This is quite wide so make sure you have plenty of space around your outlet. I couldn't install mine since my outlet was too close to the wall, but that's my bad for not checking.
13 mars 2022
Does what it's supposed to do. It's a bit bulky and of course that means traveling with it is a bit more difficult. Stand is a bit heavier that I'd like, but it adds to the sturdiness of it. Perfect for if you're just going to leave it in one place.
24 jan. 2022
Works great. Now I only need to plug in one cable to my laptop and have a wired ethernet too. Would be perfect if it was dual HDMI with ethernet.
24 jan. 2022
It's soap, it foams, and it smells like vanilla. Not much else to say about it. I do wish there was a fragrance-free version though as I'm not a fan of all these fragrances that are most likely made from (or enhanced with) chemicals.
15 déc. 2021
Pretty big in size. Currently using one to store flour. Much easier (and cleaner) than taking out the bag of flour everytime I needed it. The scoop included is a bit smaller than I thought. There are no markings on the scoop so I don't know the capacity of it, but if I had to make a very rough estimate, I would say it's around 250ml. There were no instructions that came with this so I had to YouTube how to take the lid apart to wash. Turns out that the white bottom plate is just clipped on to the silicone seal and can be pulled apart from the corners. The silicone seal can then be pulled off. I just washed the seal and the bottom plate as I didn't want to get the locking mechanism in the lid wet and risk breaking it.
15 déc. 2021
No assembly required which is nice. Build quality feels nice too, table top is some sort of wood. Not solid wood, but some kind of composite wood with a laminate finish. the legs are a type of lightweight metal, but all the clips and joint pieces are plastic so only time will tell how long it will last. Adjusting the table angle and height is very easy. For angle adjustment, you just flip two plastic tabs (one on each side) and then adjust the it. The angles are all predetermined so you can't make fine adjustments to it. As for the height, you just press the plastic button-thing on the side of the leg and adjust the heights. The heights are also all predetermined by notches in the legs. The button is spring loaded so once you release it, it will lock into place once it slides into a notch.
15 déc. 2021
O.M.G is this thing hard to put together. It doesn't come with any tools and it's all pressure fitted together. The frame is just plastic with holes for the metal rods to insert into. But the holes are always a bit too small so the rods never go in unless you use a lot of force. If you get this, make sure you have a rubber mallet handy as you will need it. I tried using my palm since I didnt have one and now it's sore. Once built, it's nice and sturdy. It replaced a coat rack and now everything looks neater.
15 déc. 2021
It's quite long and can be a bit awkward for people with small hands to hold. It works great, but my only complaint is that the attachments are very difficult to remove and I already broke my frother attachment after a few uses. Luckily, Shopper+ customer service is great and a replacement is on it's way. my tip for others is to not push the attachment all the way in. Just go enough so that it's tight enough to stay on. When removing it, use a butter knife or something similar and gently pry it off (little-by-little and alternating sides so that you don't break it).
28 nov. 2021
Bought the white one. Went to take it out of the box and hand was full of paint flakes. Proceeded to assemble one of the cubes and hand was covered in even more paint flakes and gave up after that. Product seemed like a great idea, but sadly quality of paint used or QC was lacking. Not sure I like the idea of paint flaking off so easily as I don't want to accidentally breathe them in.
20 fév. 2020
Réponse de notre service à la clientèle
Dear customer ,thanks for your kind reviews .Any quality issue ,could you contact our customer service for help ?You could reach them by calling 1-866-979-7463 or sending online live chat (from Monday to Friday )or sending an email inquiry to us (any time ). We are more than happy to help you here .Best regards
They said it was white, but the ones I got were more of an Ivory white or a light beige white colour. I was hoping for white white. Other than that, I'll just have to wait and see how these hold up to the test of time.
16 sept. 2019
Réponse de notre service à la clientèle
Hi there Steven,
We are very sorry for the inconvenience.
If you would like to discuss the details of your order, please don't hesitate to contact our customer service department.
Reviewing the SW-WS-10. It's a bit smaller than I thought it would be, but it's nice and sturdy once built. It does recommend using a rubber mallet for securing the shelves. A couple things I ran into with this was that 1) one set of the plastic insert things did not work. It would slide down every time I tried to secure the shelf on that corner. Luckily mine came with an extra set of the inserts. 2) Some of the plastic inserts have a very sharp point in the middle under the word "Top". I guessing this was from the injection moulding process. So for those who buy this, be careful of your fingers.
16 sept. 2019
It works as described. Build quality feels OK. As long as you mix your liquid hand soap with the proper ratio of water (the bottle is 300ml so I mixed 240ml of water with 60 ml of liquid hand soap), foam comes out without an issue.
Speaking of issues, the battery slots seems to be either a bit too small or a bit crooked as when I inserted my 3 AA batteries, the dispenser wouldn't turn on. Turns out this was because my batteries were getting stuck too low to make contact with the lid. I ended up smacking it and the batteries popped into place and the dispenser works again. As for those who said there's no indication of how to place the batteries, there are 3 very small and hard to see + symbols next to the holes for the batteries.
My last issue with this dispenser is that it will keep on dispensing foam soap if you leave you hand under the sensor. It's great for the times when you need a lot of soap, but for those with kids or those who get distracted/space out easily, this ma not be so great.
Overall, it works and I like it better than having to manually pump out the soap.
16 sept. 2019
Great little velcro straps to help with cable management. Different colours allows for colour coding or for style. Would be nice if there were the option to get them all in one colour though.
04 sept. 2019
Réponse de notre service à la clientèle
Dear customer, thanks for writing in, we appreciate your feedback, please call us at 1-866-979-7463 or email us at support@123ink.ca if you have any questions.
Quality feels great on this mouse pad. Mouse glides well on it. Also feels nice when resting palms on it as opposed to resting on the glass table top. Only complaint is that it has a pretty strong chemical/rubber smell. It's been sitting on the desk for a few days now and it's still smelling very strong which makes it hard to work at the computer without having to take a break for air every 5-10 minutes.
04 sept. 2019
Réponse de notre service à la clientèle
Dear customer, thanks for writing in, we appreciate your feedback, please call us at 1-866-979-7463 or email us at support@123ink.ca if you have any questions.
Great basic surge protector. Helps reduce the space needed by plugs hidden behind dressers and such. It plugs into the bottom of the two outlets on the wall with an addition plastic prong that goes into the ground hole of the upper outlet. It doesn't screw in to the wall plate/outlet so heavy transformer plugs may cause an issue with it staying in place.
04 sept. 2019
Réponse de notre service à la clientèle
Dear customer, thanks for writing in, we appreciate your feedback, please call us at 1-866-979-7463 or email us at support@123ink.ca if you have any questions.
It's a kitchen scale and does what it's supposed to. Can cycle between grams, oz, ml, and lbs oz. It also requires two AAA batteries, which does not come with it.
14 mars 2019
Great space saver, but quality no so great. The metal poles were painted poorly - some ends were wider than others because paint pooled and dried. The little holes in the plastic sides that were meant for the pegs from the previous sections to slide into were not properly cleaned/drilled. There would be residual plastic in the little holes causing the pegs not to go in all the way which meant it wasn't securely in place. I had to scrape it out in order for it to fit. Lastly. you will need to find a way to secure the bottom to the door either by a small nail, or double sided tape. Reason being is that if you remove your shoe,and accidentally pull on the rack, all your smaller shoes may side forward and fall down.
14 mars 2019
Finally had time to assemble this to test while waiting for my table top.
First off, the box was totally torn apart on one end. Most likely from shipping as the shipping label was re-taped onto one end of the box.
Assembly of the table frame was straight forward. You may need two people to make it easier as it may be a bit difficult for some due to the weight of some pieces. I was able to have it assembled in about 10-15 minutes.
One assembled, the lowest height shown on the contour unit is 62cm, but the actual height of the frame without a table top is roughly 60.8cm. The highest it goes is 125cm. Actually measured height without a top is 124.3cm. Your actual height may vary slightly due to manufacturing.
The motors itself are quiet, but not near silent. You will still hear it. Pressing the height adjust buttons once will move the table by 1cm. If you hold it and release it when the table is moving, there is a slight delay before it actually stops - the delay is roughly 1cm from when you release the button. The max load this frame is rated to lift is 125kg. It's duty cycle is 2 minutes of continuous run time followed by a minimum of 18 minutes of rest time. This is to avoid burning out the motors.
Overall pretty happy with this product. Can't wait to get my table top so I can start using it.
24 fév. 2019