Skip event schedules, enjoy lowest prices with our PLUS Membership!
Become a PLUS Member immediatelyOur processing time for orders may take up to 24-48 hours. Once processed, the estimated delivery time can take anywhere from 1-5 business days depending on the shipping destination.
FREE SHIPPING* on all orders over in Canada !All orders under , the cost of shipping is only ! *Free shipping is not available when the shipping address is a remote location.More >>
Our processing time for orders may take up to 24-48 hours. Once processed, the estimated delivery time can take anywhere from 1-5 business days depending on the shipping destination.
FREE SHIPPING* on all orders over in Canada !All orders under , the cost of shipping is only ! *Free shipping is not available when the shipping address is a remote location.More >>
Digital Handheld Laser Distance Measurer, 40 Meter (131Feet) - PrimeCables®
Seems to work well. Perfect for quick measurements. Has some nice calculation features built in. Screen is much more vibrant than it appears on the photo. Good tactile buttons. The case it includes is a little snug for the device, but good to protect it when not in use. Excellent price for what it can do.
I have to admit I was a little skeptical due to some negative reviews and low price but decided to give it a shot. So yes, you can't just blindly trust to first detection signal you get as you might get different results. But you can ensure overlapping results to ensure you get right reading. To do this I used two passes: Stick on wall 2 horizontal lines of painters tape, so that second one is below first one (in my case ~20 cm just to prevent if I hit some horizontal obstructions behind the wall) 1. First pass is to go with device left to right and mark (both beginnings and ends) on painters tape where you get reading, then do in opposite direction from right-left. If marks are matching than you're probably already ok. 2. On second line below repeat same procedure. That's it, find where you see overlapping and this is your studs. Aim to drill in the middle between begging and end markings and there you go. If you still have doubts, on every measurement tape there is little triangles with standard distance between studs, so you can check this as well against your markings. It should match.
Great tool.
Like the idea but a bit weird to get used to at the start (not simple to use IMHO).
I opened the box for this little laser measuring tool, added fresh batteries, turned it on, screen showed some activity but showed no measurement, then turned itself off after about 10 seconds. After that, it never responded again. Bought it on clearance so I can't return it. Complete waste of money :(