Definite design flaw in the manner that it is mounted. You will have to go out and buy two teeny-weeny #4 wood screws in order to hang it. I doubt they will stand up to the wear and tear of constantly pulling out plugs from the bar. Those thin screws usually break off after a time. They are so thin, even just screwing them into a pressboard desk will cause them to twist off if you aren't really careful. I might have to use permanent adhesive instead, to mount this thing. I didn't even notice the LED lights until it came in. That's a nice feature. They are very bright. I like that the sockets are bright yellow to see them, and the 2 USB charging sockets.

Had to make my own mounting brackets for this outlet as I could not find a screw head thin enough to to slide in into the mounting slots on the back of this outlet without damaging, and at that point mounts are useless . Also to note the mounting slots should of been 16” a part there was lots of space to do so.