This frame is extremely well built and has a very powerful lift. It is very stable and secure. I threw on 2 monitors, including a heavy 24" cintiq and it picks up effortlessly. For adjusting height and sitting positions, I just set the height to lower chest each time, and I have a poster that lines up from the bottom to the edge of the desk for sitting. I would recommend this to anyone thinking of getting a standing desk. Really good quality on this one. Great choice. Im so happy with this.

Ensure your tabletop is minimum 3/4" thick, ideally 1" thick, otherwise the screws may poke through to the other side. Instructions for assembly were great. motor goes up and down easily. control pod is easy out of the way. Cable management hooks provided. I would like to see an easier way to mount power bars under neath. Updated to include photo.

le mécanisme a arrêté de fonctionner après une semaine

Purchased over 4 of these now for our office. One of the most economical standing desk frames on the market. Extremely high quality product.

Ensure your tabletop is minimum 3/4" thick, ideally 1" thick, otherwise the screws may poke through to the other side. Instructions for assembly were great. motor goes up and down easily. control pod is easy out of the way. Cable management hooks provided. I would like to see an easier way to mount power bars under neath.

Pretty good desk frame. Solid build quality. Gave it 4/5 because I needed a few back and forth with support which took weeks for an issue where the desk would stop rising/lowering and reverse a few inches. For anyone with this issue, you need to make sure the control box is solidly secured to the desk. In my case this was not enough and had to disable the collision detection by holding the up+down arrows for 5 seconds. You can adjust the sensitivity from 0-4 with 0 being disabled. I wish this was in the manual.